![]() ![]() 5" deeper by decreasing cutter length offset.Īs to using third party software to verify the G-Code- its a good piece of mind when using several work offsets at the same time.įor me its very helpful to post the code and then quickly backplot the raw toolpath from top and sides to see if the part is gonna be machined on the right side of the table. We only use wear offsets to get the part in accordance to the drawing\model. I believe the part should be machined to the model and if drawing says otherwise then one of them should be fixed. ![]() Whenever i get to change something on the part, i make designers to change the model first. ![]() The fact that someone fixed the program by hand does not mean next time same part will not be scrapped just because it was reposted. Dunno about you guys but i totally disagree on having to pay thousands of bucks for a CAM system that has its own verification engine.Īnd then editing the program by hand. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |